6. Operational Precautions
Heating is not permitted during refueling or in confined
spaces (closed parking lots, workshops or ferry cabin).
Regularly check that the intake and exhaust pipes are in
good condition and that the fixing is reliable, especially
after a trip. Also check the fixing of the intake and exhaust
pipes and the exhaust cowl.
When a black smoke occurs, the heater must be
inspected and repaired by professionals authorized by the
company!
Make sure that the exhaust pipe at the exhaust cowl and
intake pipe is unobstructed, and there are no obstructions
such as snow mud, ice accretion, and leaves.
The warm air outlet and the circulating air inlet are
unobstructed to prevent the heater from overheating.
Under overheating the overheat switch will immediately
cut off the fuel supply.
If the diesel heater is to meet the heating need during
driving, a safety shut-off device should be installed.
★If without a safety shut-off device,the heater must be
shut off before driving.
12V Fuse
Replace only with the exact same fuse T20A.
~220V Fuse
★ Fuse and Wire harness must be replaced by
professionals authorized by the company.
★ All power must be disconnected before opening the
control enclosure.
Fuse specification: T20A slow fusing
~220V Overheat Protection