JR A Series - PRODUCT CARE AND SPECIFICATIONS; Cleaning & Care Instructions; Maintenance and Removal; Technical Data and Wind Limits

CLEANING & CARE
• Use suitable climbing aids.
• Do not use any high-pressure cleaner, scouring agent or scouring
sponges for cleaning.
• Solvents may not be used.
CLEANING THE PRODUCT
Dirt can be removed from the Patio Awning with a soft brush or hand
brush, mild detergent and warm water.
Clean the awning fabric with a soft brush and warm water only – any
form of detergent may erode the Teon coating on the fabric.
After cleaning, the awning fabric must be dried.
MAINTENANCE
The Patio Awning should be serviced regularly by a qualied person
and is to be examined for signs of wear and tear to fabric and system
on a regular basis.
If there is a fault, then the specialist retailer or a suitable service
provider is to commission a repair from James Robertshaw or one of its
approved agents.
Patio Awnings in need of repair may not be used.
REMOVAL
Only allow removal to be carried out by James Robertshaw or one of
its approved agents.
PRODUCT INFORMATION
TECHNICAL DATA
The dimensions and technical details of the Patio Awnings
can be reviewed on the website
www.jamesrobertshaw.co.uk.
Data for the electric drive: Mains voltage 230V AC
Current consumption: 0.45 to 2.1 Ampere (depending on drive)
Power consumption: 90 to 460 Watt (depending on drive)
Class of protection for electric drive: IP 44
Continuous operation motor: approx. 4 minutes
The electric motor is not designed for continuous operation.
After approximately 4 minutes of operation, the thermal
protection engages and the motor switches o.
After 15-30 minutes the motor is operational again,
however within 1-2 minutes the renewed actuation time
is signicantly reduced.
WIND LIMITS
Depending on the quality of the product, awnings are classied
according to DIN EN 13561 Point 4.3. into wind resistance
classes. The higher the class, the higher the quality of the product.12)
NOISE EMISSIONS
The noise level of this awning, in a non-installed state, measured
according to EN ISO 12100-2:2003, is below 70dB(A).
USER GUIDE
PROJECTION
(mm)
1500 2000 2500 3000 3500 4000
BOBCAT 250 2 2 2
CHEETAH 3 3 2 2
PUMA 3 3 2 2
SUNBOX 2 2 2 2
ZEPHYR 3 3 3 2 2
JAGUAR (NO
VARIABLE
VALANCE)
3 3 3 3 3 3
JAGUAR (WITH
VARIABLE
VALANCE)
3 3 3 3 2
PANTHER (NO
VARIABLE
VALANCE)
3 3 3 3 3 3
PANTHER (WITH
VARIABLE
VALANCE)
3 3 3 3 2
COUGAR (NO
VARIABLE
VALANCE)
3 3 3 3 3 3
COUGAR (WITH
VARIABLE
VALANCE)
3 3 3 2 2
JR A101: WIND CLASSES
WIND RESISTANCE
CLASS
DESCRIPTION BEAUFORT SCALE
WIND FORCE
WIND SPEED
CLASS 0 UNDEFINED; PRODUCT UNTESTED OR UNSUITABLE
CLASS 1 GENTLE BREEZE 4 20-27 km/h
CLASS 2 FRESH BREEZE 5 28-37 km/h
CLASS 3 STRONG BREEZE 6 38-48 km/h
WIND LIMITS