JR ProPo XG8 - 54_Copy_Erase

53
MODELCOPY&ERASE
FunctionExplanation
Inthisscreen,copyinganderasingofmodeldataiscarriedout.Thiscanbeimplementedinthe
transmittermemoryandonanSDCard.Inaddition,itwillevenbepossibletocopymodeldata
betweenXG8transmittersthathavebeenconnectedusingatrainercable.
•
SettingMethod
Forsafetyreasons,ascreenthatinitiallystopstheissuingoftheradiowaveswillbedisplayed,so
select“YES”tochangethescreentothefunctionscreen.First,selecteitherCopyorEraseatthetop
rightofthescreen.Followingthis,theworkflowwillconsistofselectingthecopysourceandcopy
destinationandimplementingtheCopyfunction.
SelecttheCopySourceandCopyDestination.“INTERNAL”willbedisplayedforthetransmittermainunit,“SDCARD”willbe
displayedforthetransmitterSDCard,and“TRANSFER”willbedisplayedforanexternaltransmitter.ThenselecttheModelusing
thelowerstageofthelocationdisplay.
ImplementationiscarriedoutusingtheFUNCTIONkeyshownatthebottomleftofthescreen.Duringthecopyingprocess,the
displaywillbecleared.Donotpressanyofthekeysandwaituntilthe“ALLOK”messageisdisplayed.
•
Whenanewlycopiedmodelistobeused,itwillbenecessarytocarryoutthebindingwiththereceiveragain.
Inthesituationwherethemodeliscopiedinsidethetransmitter,itwillnotbepossibletooverwritethedata
ontopofanexistingmodel.Eithererasetheexistingmodelorcarryoutcopyingtoanemptymemory.
Inthecasewhereyouerasethemodelthatiscurrentlybeingused,theSettingNavigationwillbeautomati-
callystartedup.
InthesituationwherethecopyistobemadetoanSDCard,registrationofthesamenamewillnotbepos-
sible.AGuidewillbedisplayed,soinputadifferentFilename.
•
•
•
•
Whilethisscreenisbeingdisplayed,andduringcopyimplementation,absolutelydonottake
outtheSDCardunderanycircumstances.
TherewillbeadangerofdestroyingtheModelData.
Actuallyoperatetheservosandcarefullyconfirmthesettingsbeforeflying.
•
•
Hints
【COPY/ERASE】
CautionItems
●Copy/EraseScreen[COPY],[ERASE]
WhenconnectingthetransmittertoanexternalXG8,setthepowerswitchesofbothtransmitterstoOFF
beforeconnectingthetrainercable.ThepowerwillswitchONautomatically.Followingthis,seteachofthe
transmitterscreenstotheconditionshownbelow,thencarryoutthetransferbypressingtheFUNCTIONkey
ofthecopysourcetransmitter.Inthesituationwherethereisaproblemwiththecableconnection,anerror
willbedisplayed.
●
ScreenforDataTransfertoanExternalXG8Unit
EachFunctionintheSystemList
Helicopter
Airplane
Glider
CopyScreen EraseScreen
CopySourceTransmitter PartnerTransmitter
CopySource
CopyDestination
ModelNo.
ModelNo.
Name
Name
CopyImplementation OperationSelection EraseImplementation
【COPY】/【ERASE】 【YES】