4-1
FLYBAR CONTROL ARM/SEESAW ARM ASSEMBLY
4-2
MAIN BLADE HOLDER ASSEMBLY
61
Center Hub
Main Blade Holder (2)
Seesaw
Seesaw Arm (2)
Ball Bearing
Seesaw Mounting Bolt (2)
2x12 mm Flat Head Screw (2)
Joint Ball (6)
2 mm Hex Nut (2)
Flybar Control Arm
Flybar Stopper (2)
Flybar
4x4 mm Set Screw
Ball Bearing (2)
2x10 mm Flat
Head Screw (4)
Seesaw Arm
Bushing (2)
3x16 mm Socket Head Bolt (2)
3 mm Flat Washer (4)
Ball Bearing
3x16 mm Socket Head Bolt (2)
2x10 mm Flat Head Screw (4)
2x12 mm Flat Head Screw (2)
3 mm Flat Washer (4)
2 mm Hex Nut (2)
Joint Ball (4)
4x4 mm Set Screw (2)
4 mm Lock Nut (2)
4 mm Lock Nut (2)
Spindle Shaft
Damper Rubber (2)
Main Blade Spacer (2)
Damper Rubber 50° (2)
Main Blade Spacer (2)
When removing the main blade holders, it will be necessary to turn the
nuts both ends at a time using the two 7 mm hex nut drivers.
It will be necessary to remove one side of the main blade holders to
remove the spindle shaft.
To Next Page
Loading...
