JR Vibe 90SG - Clutch Bell Installation

15
2-4 CLUTCH BELL INSTALLATION
Pinion Mesh Plate (T96) (2pcs)
Governor Mount
Use this for attaching
an Optional Governor
Sensor.
Optional governor
magnets can be installed
in the predrilled holes in
the clutch bell.
Socket Head Bolt,
3 x 8mm
Socket Head Bolt,
3 x 10mm
Socket Head Bolt, 3 x 10mm
Socket Head Bolt, 3 x 12mm
Socket Head Bolt, 3 x 8mm
Flat Washer,
3mm (4pcs)
Socket Head Bolt, 3 x 8mm (2pcs)
Socket Head Bolt, 3 x 10mm (3pcs)
Flat Washer, 3mm (4pcs)
Socket Head Bolt, 3 x 12mm (1pc)
deR
deR
Note: Do not tighten the 3 x 10mm
and 3 x 12mm bolts completely at
this time
Note: Tighten the 3 x 8mm bolts
completely at this time to locate
Mesh Plates