JR Vibe 90SG - Tail Gear Case Installation 2

37
Flat Washer, 3mm (2pcs)
Vertical Fin
Button Head Bolt, 3 x 6mm (2pcs)
Position the vertical n so that it is
perpendicular to the building surface
(parallel with the main rotor shaft) and
tighten the tail gear case clamp bolt
from the previous step.
5-4 TAI L G E A R CA SE INST A LL A T I ON 2
Button Head Bolt, 3 x 6mm (2pcs)
Flat Washer, 3mm (2pcs)
Button Head Bolt, 3 x 4mm (1pc)
Socket Head Bolt, 3 x 10mm (1pc)
Button Head Bolt, 3 x 4mm
Socket Head Bolt, 3 x 10mm
deR
deR
)2x(
deR
Position the vertical n so that it is
perpendicular to the building surface (parallel
with the main rotor shaft) and tighten the tail
gear case clamp bolt from the previous step.
Do not over-tighten and deform the clamp.