JR Vibe 90SG - Tail Pitch Control Lever Installation

38
Tail Pitch Slider Bolt (2pcs)
Tail Pitch Control Lever
Tail Slide Ring Sleeve
Circle Marks
Tail Pitch Plate
Steel Joint Ball
Tail Pitch Link Pin (2pcs)
CA Stopper Ring, 2mm (4pcs)
This Position
Button Head Bolt, 3 x 8mm (2pcs)
Bearing, F4 x 7 x 2.5mm(2pcs)
Tail Pitch Base Bearing Collar (2pcs)
Flat Head Screw,
2 x 8mm
Tail Pitch Slider
Ring Assembly
This is reverse (left hand)
thread. Use caution when
installing.
5-5 TAI L P I TCH C ONTROL L EVER INST A LL A T I ON
Button Head Bolt, 3 x 8mm (2pcs)
Tail Pitch Slider Bolt (2pcs)
Tail Pitch Base Bearing Collar (2pcs)
CA Stopper Ring, 2mm (4pcs)
Tail Pitch Link Pin (2pcs)
Steel Joint Ball (1pc)
Flat Head Screw, 2 x 8mm (1pc)
Tail Pitch Link (2pcs)
Note the proper direction
The side with four circle marks
of the Tail Pitch Link.
is toward the direction
of the arrow.
Tail Pitch Slider
Ring Assembly
Tail Pitch Slider Bolt
Install the Tail Pitch Control Lever
in this drawing.
O-ring, 5 x 7 x 1mm (2pcs)
O-ring, 5 x 7 x 1mm
deR
(x2)
(2pcs)
Install the Tail Pitch Slider as shown
in this drawing.