JR Vibe 90SG - Jr 12 X Programming

49
JR 12X PROGRAMMING
The following activation and setup procedure should be used for JR 12X systems. Prior to activating the CCPM
function, it is rst suggested that the data reset function be performed to reset the desired model number to be
used back to the factory default settings.
Caution: Prior to performing the data reset function, it will be necessary to select the desired model
number to be used.
A) Model Select/Data Reset
PresstheENTkeywhileturningthepowerswitchontoenterthesystemmode.Next,movethecursortotheMODEL
SELfunction.Presstherollselectortoenterthemodelselectfunction.Selectthedesiredmodelnumbertobeused,
then press the roll selector. Next, move the roll selector to highlight LST, and press the roll selector. Move the roll
selectortohighlightMDLRESET,thenpresstherollselector.PresstheCLEARkey,thenpressYEStoresetthedataof
the current model selected.
B) Device Select
MovetherollselectortohighlighttheDeviceSELfunction,thenpresstherollselectortoaccesstheDeviceSelect
function.Next,movethecursortotheOUT:columnintheGEARrowandselecttheGOVsetting.Next,movethe
cursortotheOUT:columnintheAUX2rowandselecttheGYRsetting.