JR Vibe 90SG - Page 51

51
E) Servo Reversing
MovetherollselectorandhighlightREV.SWonthescreen,thenpresstherollselectortoenterthefunction.Next,
reversechannels1,2,3and4bymovingtherollselector,andpressingasneededtochangefromNORMtoREV.
Press the LST key to return to the menu.
F) Travel Adjustment
MovetherollselectoruntilTRVLADJishighlightedonthescreen,thenpresstherollselectortoenterthefunction.
Adjustthevaluesasshownbymovingtherollselectortohighlightthedesiredchannel,whileusingthecontrolstick
toselectup/down,orleft/rightvaluestobeadjusted.Pleasenotethattherequiredtravelvalueswillvarybasedon
the type of servo selected. Press the LST key to return to the menu.
G) CCPM Settings
MovetherollselectortohighlighttheSWASHMIXfunction,thenpresstherollselectortoenterthefunction.Setthe
value of the aileron, elevator, and pitch functions from the factory default setting using the rolling selector. Press the
LST key to return to the menu.