JR Vibe 90SG - JR 7202 and SPEKTRUM Dx7 Se and DX7: PROGRAMMING

57
JR 7202 AND SPEKTRUM DX7se AND DX7: PROGRAMMING
The following activation and setup procedure should be used for the JR 7202, Spektrum DX7se and DX7 systems.
Prior to activating the CCPM function, it is rst suggested that the data reset function be performed to reset the
desired model number to be used back to the factory default settings.
Caution: Prior to performing the data reset function, it will be necessary to select the desired model
number to be used.
A) Model Select/Data Reset
Press the Down and Select keys while turning the power switch on to enter the system mode. Next, move the
cursortotheMODELSELfunctionwiththeUPkey.Selectthedesiredmodelnumbertobeusedwiththeincrease
ordecreasekey.Next,presstheUPkeyuntilMODELRESETisdisplayed.PresstheCLEARkey,thenpressYEStoreset
the data of the current model selected.
B) CCPM Activation
PresstheUPkeyuntiltheSWASHTYPEfunctionisdisplayed,thenpresstheINCREASEkeytoselect120CCPMtype
as shown.