JR Vibe 90SG - Page 60

60
H) Throttle Hold Setting
PresstheUPkeytoselecttheTHROHOLDfunction.PresstheINCREASEkeytoactivatethefunction.
Once the throttle linkage is set up, set the hold position in this function so that when the throttle hold
switch is pulled, the throttle servo does not move with the throttle stick at idle and throttle trim set at
the idle position.
I) Gyro Sensitivity Selection
PresstheUPkeytoselecttheGYROSENSfunction.SetthegyrogainasshownasastartingpointfortheG7703D
gyro.Adjustthepercentageasnecessarywhenyingtheheli.Othergyrosmayrequiredierentsettings;consult
your gyro manual for further information on setting the gain.