Type B Servo Mounting Plate (4pcs)
Aileron Servo (Ch 2)
Rudder Servo
Flat Washer, 2.6mm (8pcs)
Self-Tapping Screw, 2.6 x 12mm (8pcs)
6-1 S ERVO INST A LL A T I ON 1
Self-Tapping Screw, 2.6 x 12mm (8pcs)
Flat Washer, 2.6mm (8pcs)
Type B Servo Mounting Plate (4pcs)
We recommend the same model be used for all Swashplate servos.
Be careful when tightening the tapping bolt. If it is too loose, the servo will move.
Over-tightening it will cause damage. The ideal position will dent the rubber slightly.
Be sure to note the fore and aft position of the servo output shaft.
Screw Supplied with Switch
Switch Dampener (2pcs)
Switch Harness
Switch Dampener (2pcs)
120 CCPM
Aileron Servo (Ch 2)
140 CCPM
To Next Page
Loading...
