EasyManua.ls Logo

JR Vibe 90SG - Pitch Range and Curve Settings

JR Vibe 90SG
106 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
72
Note: Flight modes #1 and #2 are
duplicated for safety.
Throttle Curve Settings
Below are examples of possible throttle curves during
various ight conditions.
Since throttle curves can vary greatly due to engine and
muer combinations, it will be necessary to ne-tune and
adjustthesevaluesduringtestightstoachieveaconstant
main rotor rpm.
It will also be necessary to set the correct idle speed of the
engine when the throttle hold function is activated. This
idle value is located within the throttle hold function. This
will allow the engine to remain at idle when practicing
autorotations.
Gyro Gain Adjustment (All Gyros)
Please refer to your Gyros instruction manual for proper gain
settings.
Gyro Direction
It will also be necessary to conrm the direction the gyro
compensates when the body of the helicopter is rotated. To
do this, turn the radio system on and suspend the helicopter
by the main rotor head. Next, move the rudder stick to the
right and watch the direction that the tail rotor servo arm
travels. Now while watching the tail rotor servo arm, rotate
the body of the helicopter counterclockwise. The servo arm
should move in the same direction as when the rudder stick
was moved to the right. If the arm moves in the opposite
direction, reverse the gyro and re-test. Generally with the
G770 3D Gyro, it will be necessary to reverse the direction of
the gyro with the switch on the gyro.
Governor Setting
Set the Governor settings as shown in the radio
programming section. Set the throttle curve in normal mode
as shown, then set the throttle curves in stunt 1 and 2 up to
beastraightlineatthetopofthegraph(+100%)andadjust
thegovernorsettingstoadjustheadspeed.Ifnotusinga
governor, you will need to set V-shaped throttle curves in
stunt 1 and 2, with the throttle set to +100% at full negative
and positive pitch, and 60% to 70% at center stick.
Normal
(Hover)
Stick Position
Pitch Range
Flight Mode 1
3D Stunt 1
Stick Position
Pitch Range
Stick Position
Pitch Range
Flight Mode 2
3D Stunt 2
(Duplicate of #1)
Autorotation
(Throttle Hold)
Stick Position
Pitch Range
+12º
-12º
Low 1/4 1/2 3/4 High
+12º
-12º -9º
+12º
-12º -9º
Low 1/4 1/2 3/4 High
Low 1/4 1/2 3/4 High
+12º
-12º
Low 1/4 1/2 3/4 High
Pitch Curve Settings
N
1
*2
H
Hovering
3D Flight #1
3D Flight #2
Autorotation
-12º
-12º
-12º
-12º
+12º
+12º
+12º
+12º
Flight
Mode
Application
Low Pitch
(Low Stick)
Hovering Pitch
(Half Stick)
High Pitch
(High Stick)
Pitch Range Settings
Hovering
Stick Position
Power Output
Normal Mode
Flight Mode N
3D Flight Stunt 1 and 2
Stick Position
Power Output
Flight Mode 1
100%
50%
0% (Idle)
40%
60%
1
2
3
4
Low 1/4 1/2 3/4 High
100%
50%
0% (Idle)
40%
Low 1/4 1/2 3/4 High
Throttle Curve Settings
PITCH RANGE AND CURVE SETTINGS

Table of Contents

Related product manuals