3-58
Handwritten data created is automatically saved every five seconds; no operation is needed.
Compatible ECDIS devices are shown below.
No. ECDIS device Output format
1 JAN-701B/901B (JRC) U_NeCSTd.uch
2 JAN-7201/9201 (JRC) U_NeCSTd.uchm
3 FMD-3100/3200/3300 (FURUNO) U_NeCSTd.xml
Note
There are cases where exported handwritten data cannot be used on ECDIS.
In the case, check the instruction manual of the ECDIS and correct the parameter value of
handwritten data to a value less than the upper limit.
Using Exported Handwritten Data on ECDIS
The following is an example of using on ECDIS (JAN-7201/9201 and JAN-701B/901B) handwritten
data created on this equipment.
[JAN-7201/9201]
■If the Soft Version of JAN-7201/9201 is 01.30.110 or later, you can use the following
procedure.
The File Operation dialog box of User Chart is displayed.
Memo
If the JAN-7201/9201 is started before J-Marine NeCST, linking may not work properly.
Restart the JAN-7201/9201.
To Next Page
Loading...