3-87
Changing Sticker Size and Direction
The size and direction of a placed sticker can be changed.
Handwritten data created is automatically saved every five seconds; no operation is needed.
Compatible ECDIS devices are shown below.
No. ECDIS device Output format
1 JAN-701B/901B (JRC) U_NeCSTs.uch
2 JAN-7201/9201 (JRC) U_NeCSTs.uchm
3 FMD-3100/3200/3300 (FURUNO) U_NeCSTs.xml
Note
There are cases where an exported sticker cannot be used on an ECDIS.
In the case, check the instruction manual of the ECDIS and correct the parameter value of
sticker to a value less than the upper limit.
The size of these stickers can be
changed.
The direction of this sticker can be
changed.
To Next Page
Loading...