JRC J-Marine NeCST - Updating software; Performing software update

3-186
3.23 Updating software
CAUTION
Don’t turn off the power when updating software.
If the power supply is interrupted during the update, the update cannot be
executed normally.
When starting software update, the NeCST application is automatically terminated.
NeCST application cannot be used until update is completed.
Avoid updating while navigating, update with a margin.
Also, if the EncManager application and Set
ting tool application are running,
update processing may not be completed. Close those applications and then run
the update.
Access to “http://192.168.XXX.XXX/NeCST/home/updatepackage”.
In “192.168.XXX.XXX”, the IP address of the data processing unit is set.
The default IP of data processing unit is 192.168.100.240
When the upload is completed, the display returns to the original display. "Drop .necstpackage files
here or click in this area."