JRC J-Marine NeCST - Powering ON and Starting

3-5
3.2 Powering ON and Starting
CAUTION
If the power is turned ON in an incorrect order, the equipment may fail to boot
normally.
In that case, turn OFF the power of the equipment, and then turn it ON in the correct
order.
To turn ON the power, follow the following steps.
Note
Turn on ECDIS after starting up this equipment.
If ECDIS is started before this equipment, link function may not behave normally.
If equipped with JAN-901B/701B, turn on JAN-901B/701B before starting up this equipment.
Perform preheat for 3 minutes or longer after turning ON the power.
Otherwise, the server may not operate normally.