JRC JAN-701B - Selecting Motion Mode

3 Basic Operation of ECDIS 3-69
ECDIS
3.7.1 Selecting Motion Mode
You can select Motion mode using the display panel.
Note:
• While [Chart Portfolio] is running, Motion mode [Relative] cannot be selected.
(1) Selecting Motion mode using the display panel
1) On the display panel
Left-click the Motion drop-down list.
2) Select one of items (True, Relative, Free) by left-clicking it.
3.7.2 Selecting Azimuth Mode
You can select Azimuth mode using the display panel.
(1) Selecting Azimuth mode using the display panel
1) Left-click the Azimuth drop-down list on the display panel.
2) Select one of items (North Up, Course Up, WPT Up) by left-clicking it.
Then, the display changes according to your selection.
• If you select [Rotation], enter its rotational angle in degrees. (000.0 – 359.9 degrees).
• If [True] or [Free] is selected in Motion mode, “Course Up” and “WPT Up” cannot be selected.
Motion drop-down
list button
For [Rotation] mode
Azimuth drop-down
list button