JRC JAN-701B - Selecting Chart under Cursor (ARCS Only)

3 Basic Operation of ECDIS 3-75
ECDIS
3.10.2 Selecting Chart under Cursor
(ARCS Only)
1) Or right-click on the chart, then select [Select Chart under Cursor] from the context menu.
Move the cursor to the desired chart with the track ball, then left-click to open the [Select Chart]
panel.
2) Left-click the chart No. you want and then left-click the [OK].
The panel closes and the selected chart is displayed on the screen.
• If Preview is turned on, a low resolution chart of the temporarily chosen chart will be displayed.
Note:
• When a chart is not displayed but a corresponding chart is displayed in the display area, the area
where a chart exists will be displayed in blue and the area where a chart does not exist will be
displayed in gray.