3 Basic Operation of ECDIS 3-111
ECDIS
3.15.3.1 Drawing and deletion EBL by the Display panel
The following description is an operation of EBL1. EBL2 becomes a similar operation.
(1) Drawing EBL1 and setting the bearing
1) When “EBL1 edit button” is inactive
, left-click to this button.
Then, “EBL1 edit button” is changed active and EBL1 is displayed.
At the same time, EBL1 bearing is changed with the cursor.
2) Move the cursor and left-click at the bearing you want. Then, EBL1 bearing is fixed.
(2) Deletion EBL1
1) When “EBL1 edit button” is active
, left-click to this button.
Then, “EBL1 edit button” is changed inactive and EBL1 disappears.
3.15.3.2 Drawing and deletion VRM by the Display panel
The following description is an operation of VRM1. VRM2 becomes a similar operation.
(1) Drawing VRM1 and setting the distance
1) When “VRM1 edit button” is inactive
, left-click to this button.
Then, “VRM1 edit button” is changed active and VRM1 is displayed.
At the same time, VRM1 distance is changed with the cursor.
2) Move the cursor and left-click at the distance you want. Then, VRM1 distance is fixed.
(2) Deletion VRM1
1) When “VRM1 edit button” is active
, left-click to this button.
Then, “VRM1 edit button” is changed inactive and VRM1 disappears
Lift-click to the “EBL1 edit button”
Lift-click to the “VRM1 edit button”
To Next Page
Loading...
