3 Basic Operation of ECDIS 3-141
ECDIS
3.25 Cursor Auto Mode
The auto mode is the mode that the display of the contents and the change of the setting can be
implemented by repeating a cursor in the specific object and the line.
The cursor becomes a crosshair cursor.
“Navigation & Planning” The initial condition in case of start-up becomes an auto mode about the sailing
executive-state.
When choosing [AUTO mode] from the context menu when a cursor is displayed at the thing except the
crosshair cursor in [Zoom Area] etc, the cursor mode changes to the auto mode.
Also, it returns to the auto mode automatically when not clicking for 1 minute when a cursor is displayed
at the thing except the crosshair cursor and leaving.
The selectable object and the displayed information
When adjusting a cursor to each object for 1 second, the following information is displayed.
Priority *1 Object Operation which is
possible when
left-clicking
Information which is displayed
when adjusting a cursor
1 AIS “AIS”
Ship’s name(number)
CPA
TCPA
Non-active: actived AIS target.
Active:Select List display and
being hidden.
2 TT “TT”
Target number
CPA
TCPA
Select List display and being
hidden.
3 BUOY “BUOY”
Comment
4 LIGHT
“LIGHT”
Comment
5 Cross point of EBL1 or
VRM1
(EBL1 or VRM1)
“EBL1”(“EBL2”)
“VRM1”(“VRM2”)
Changing the EBL1(EBL2) or
VRM1
(VRM2);1-step operation.
6 EBL1(EBL2) “EBL1”(“EBL2”) Changing the EBL1(EBL2)
7 VRM1(VRM2) “VRM1”(“VRM2”) Changing the VRM1(VRM2)
8 AZ1(AZ2) “AZ1”(“AZ2”) Changing the AZ1(AZ2)
The item to change by the place to
click is different.
・ Start Side
・ End Side
・ Far Side
・ Width
To Next Page
Loading...
