JRC JAN-701B - Selecting the Route and the WPT

6 Automatic Sailing
6-8
6.3.1 Selecting the Route and the WPT
To select the route, use the [Route] on the display panel.
●When using A/P that is not TCS type
Selecting Normal route (extension “.rtn”).
●When using A/P that is TCS type
Selecting TCS route (extension “.rta”).
The route where the Limit Check and Safety Check by Route Planning was done is displayed in the
left of route name, "OK>".
To select the WPT, use the [To WPT] on the display panel.
Normal Route
TCS route that doesn't Limit check and Safety
check by Route Planning
TCS route that does Limit check and Safety
check by Route Planning