7 Tools and Setting/Serviceman Menu
7-8
The secondary position symbol is displayed as “◎” regardless of the scale. The track information for
the past six minutes is displayed in green. Other information cannot be displayed. The symbol and
track can also be turned ON and OFF.
7.5.2 Bearing Setting
1) In the normal menu
Select [MENU] - [(7) Main] - [(4) Sensor] in that order.
The “Sensor Connection” panel opens.
2) Left-click the item to select it, and enter value to the value entry box.
a) Use LAN / Use Local Port
Select this item if the gyro sensor is used for the heading sensor. Gyro sensor’s information
is used to determine the heading of the ship. If the sensor being used detects the synchro/
step gyro, the initial value must be entered. After entering the value, left-click the [Set]
button to fix it.
• Use LAN: This item selects when input a data from LAN Board.
• Use Local Port: This item selects when input a data from Local Port.
• GYRO I/F: GYRO i/F out put type gyro is used for the heading sensor.
• GYRO(NMEA): GYRO(NMEA) out put type gyro is used for the heading sensor.
• GYRO-Compass: Synchro/step gyro is used for the heading sensor.
• GYRO Setting: This item uses when setting to GYRO I/F or GYRO-Compass.
In the following case, GYRO Setting becomes invalid
• When selecting GYRO(NMEA) in [Source].
• It sets [GYRO I/F] and [GYRO(NMEA)] to [Not Use] by the device setting.
When setting to [Use LAN] or [Use Local Port], it is displayed with "HDG(GYRO)" in the
display panel.
b) Manual (not used usually)
Enter the value when you apply any value as the bearing of the ship.
When setting to [Manual], it is displayed with "HDG(GYRO)" in the display panel.
Selects a heading sensor
GYRO I/F
GYRO(NMEA)
GPS-Compass
To Next Page
Loading...
