8 Playback
8-6
8.2 Playing Back the Logging Data
(1) Setting the starting date/time to be played back
1) Select [MENU] - [(8) Playback] - [(1) Starting Date/Time] in that order.
Then, the “Starting Date/Time” panel opens. (Initially, this screen is displayed.)
*1 (Logging data): A series of logging files in which the logging date is continuing.
*2: Used to designate playback start time. During playback, the date and time that were
recorded are displayed.
2) Specify the above items to select the logging data to be played back, and then left-click the [OK]
button.
(2) Displaying the Playback Panel
1) Select [MENU] - [(8) Playback] - [(5) Playback Panel] in that order.
Each time you select this menu, the “Playback panel” panel is turned ON and OFF. When it is
ON, the panel appears in the display panel.
Note that, depending on the playback status, some buttons are inactive.
• Even if the “Playback Panel” panel is closed, you can start, pause, or stop the playback from
the menu.
Logging data drop-down list*
1
Date and time of recording end
Date and time of recording start
Selection of date and time to be played
back*
2
(You can select date and time by sliding
the scroll bar or entering the values.)
[Pause] Button
[Stop] Button
[Date/Time] Button
Left-clicking this button will open the
“Start Date/Time” panel as shown above.
[Playback Speed Select] Button
Left-click this drop-down list button and then
select the playback speed you want by left-clicking it.
[Start] Button
To Next Page
Loading...
