3. Mechanical Installation
JCY-1800/1850 VDR/S-VDR Installation Guide
57
DOC No. 7ZPJD0387C
3.9.3. Connection to the JMA-900 Chart Radar Unit
3.9.3.1. Fastening the Radar Interface Unit on the JMA-900 Chart Radar Unit
Install the Radar Interface unit (NWP-46) as follows procedure.
1）Remove the front cover of Radar
Remove the cover of Radar with reference to a
“Radar installation guide”.
Assemble the laid LAN cable and Power cable.
2）Connect the display cable to Radar
Connect the DVI plug of an attached display cable
to the jack on the AGP slot of the Radar.
Do not remove this connector when the Chart
Radar is turned on. An image data is no longer
outputted from Radar.
Caution
To Next Page
Loading...
