JRC JCY-1800 - Page 76

4. Cabling
JCY-1800/1850 VDR/S-VDR Installation Guide
66
DOC No. 7ZPJD0387C
4.2.6.2. Monitor Timing of the RADAR Video
The monitor timing of the RADAR video signal is decided based on the VESA DTMS. The VESA
DTMS stands for Video Electronics Standards Association Discrete Monitor Timings Standard.
With the VDR, the following signals can be input.
1) Resolution: Up to 16000 x 1200 pixels
2) Refresh rate: Up to 85 Hz (depending on resolution)
3) Pixel frequency: Up to 162.0 MHz
4) Scan method: interlaced / non-interlaced
5) Synchronize method: Separate / Synch on Green
Resolution
Refresh
Rate
Horizontal
Frequency
Pixel
Frequency
640 x 350 pixels 85 Hz 37.9 kHz 31.500 MHz
640 x 400 pixels 85 Hz 37.9 kHz 31.500 MHz
720 x 400 pixels 85 Hz 37.9 kHz 35.500 MHz
640 x 480 pixels 60 Hz 31.5 kHz 25.175 MHz
72 Hz 37.9 kHz 31.500 MHz
75 Hz 37.5 kHz 31.500 MHz
85 Hz 43.3 kHz 36.000 MHz
800 x 600 pixels 56 Hz 31.5 kHz 36.000 MHz
60 Hz 37.9 kHz 40.000 MHz
72 Hz 48.1 kHz 50.000 MHz
75 Hz 46.9 kHz 49.500 MHz
85 Hz 53.7 kHz 56.250 MHz
1024 x 768 pixels 60 Hz 48.4 kHz 65.000 MHz
70 Hz 56.5 kHz 75.000 MHz
75 Hz 60.0 kHz 78.750 MHz
85 Hz 68.7 kHz 94.500 MHz
1152 x 864 pixels 75 Hz 67.5 kHz 108.000 MHz
1280 x 960 pixels 60 Hz 60.0 kHz 108.000 MHz
1280 x 1024 pixels 60 Hz 64.0 kHz 108.000 MHz
75 Hz 80.0 kHz 135.000 MHz
85 Hz 91.1 kHz 157.500 MHz
1600 x 1200 pixels 60 Hz 75.0 kHz 162.000 MHz
* Scan method is non-interlaced for all the resolutions.