JRC JCY-1800 - Page 78

4. Cabling
JCY-1800/1850 VDR/S-VDR Installation Guide
68
DOC No. 7ZPJD0387C
3) JMA-900M series (Chart Radar)
Resolution 1600 x 1200 pixel
Scan Non-interlaced
Color Color
Output Signal R / G / B / Vs / Hs
Connector BNC
Vertical Refresh rate 60 Hz
Sync Impedance 75 ohms
Signal level +5.0 - 0V at 2.2k ohms termination
+2.5 - 0V at 75 ohms termination
Polarity Negative
Horizontal Frequency 75 kHz
Sync Impedance 75 ohms
Signal level +5.0 - 0V at 2.2k ohms termination
+2.5 - 0V at 75 ohms termination
Polarity Positive
Video Pixel frequency 162.000 MHz
signal Impedance 75 ohms
Signal level +0.7 - 0V
Polarity Positive
* If the Radar equipment is JMA-900M, the Radar Interface Unit (NWP-46) should be installed.
Connection cable (DVI-DSUB15) is an accessory of NWP-46.
* JMA-900M series Radar should be connected to the S-VDR
4) JMA-9800 series
Resolution 1024 x 768 pixel
Scan Non-interlaced
Color Color
Output Signal R / G / B / Vs / Hs
Connector BNC
Vertical Refresh rate 60 Hz
Sync Impedance 75 ohms
Signal level +5.0 - 0V at 2.2k ohms termination
+2.5 - 0V at 75 ohms termination
Polarity Negative
Horizontal Frequency 48.36 kHz
Sync Impedance 75 ohms
Signal level +5.0 - 0V at 2.2k ohms termination
+2.5 - 0V at 75 ohms termination
Polarity Negative
Video Pixel frequency 125.000 MHz
signal Impedance 75 ohms
Signal level +0.7 - 0V
Polarity Positive
*To make the output to the VDR viable, please incorporate an amplifier (NAD-30)
and VDR connection kit (MPBC36097) into the RADAR equipment, using a kit
provided by JRC.
* JMA-9800 series Radar should be connected to the S-VDR