JRC JCY-1800 - Installation Flow for Server PC

Chapter9 Appendix
VDR Real Time Monitor / Installation Manual
145
9.4 Installation Flow for Server PC
《 Playback only 》 《 Live only 》 《 Live + Playback 》 《 Live + Playback + Record 》
Install the VDR/S-VDR Real Time Monitor by CD-ROM.
Start the VDR Launcher.
Start the SETUP software.
Log in with Serviceman authority.（Password “
j
rcvd
r
”）
Check contents of engine, thruster, rudder, propeller, Keel – Trans and sensor sentences.
Specify Terminal1-3 IP addresses.
Specify IP address of shipboard LAN side.
Set record period and overwrite.
Specify a CF card drive.
Set existence of Terminal1-3 connections.
Set existence of Radar monitor and record.
Import VDR configuration (SysInfo.dat) from a CF card built in VDR/S-VDR.
Specify a CF card drive.
Setting Tab
System
Ethernet
Configuration
Set existence of Radar monitor.
Close
All Set
Specify a playback folder.
Set existence of audio monitor. Set existence of audio monitor and record.
Specify a folder for playback and record.Specify a playback folder.
Set real time outputs in the Option PC screen of the Maintenance software.