JRC JCY-1800 - Initial Setup for the VDR;S-VDR Real Time Monitor; Server and Client PC)

Chapter6 PC (Server/Client) Setup
VDR/S-VDR Real Time Monitor / Installation Manual
42
6.5 Initial setup for the VDR/S-VDR Real Time Monitor
Initial setup for the VDR/S-VDR Real Time Monitor is set up with the Setup software of
VDR/S-VDR Real Time Monitor software attachment. Shows the setup flow.
Server and Client PC)
(1)
VDR/S-VDR configuration reading by communication
(2) Various setups
Completion
The necessary items of initial setup are as follows
Table 6.2 Setup Item
PC Setup Tab Name
Setup of equipment connections
Recording ON/OFF
Setup of recording folder
Setup of recording period
System tab
Assignment of Client PC IP address Ethernet tab
Server
Check quantity of Engine, Rudder, Thruster,
Propeller and Keel – Trans.
Note: The data are set by Maintenance software.
If the data is wrong, setup the data by
Maintenance software again.
Configuration tab
Setup of equipment connections System tab Client
Check quantity of Engine, Rudder, Thruster,
Propeller and Keel – Trans.
Note: The data are set by Maintenance software.
If the data is wrong, setup the data by
Maintenance software again.
Configuration tab
The inputs to the unnecessary items in the setup items of Server
and Client are prevented.
Note