Chapter6 PC (Server/Client) Setup
VDR/S-VDR Real Time Monitor / Installation Manual
53
Table6.4 Setup Contents in the Ethernet Tab
No. Block Content Setup*1 Note
LAN1 (VDR Side) It is the IP address for communication with the
VDR.
U
①
Option PC
LAN2 (Terminal Side) It is the IP address for connecting with Client
PC in the user LAN.
Please change the IP address in accordance
with the user LAN allocation.
N
Connect In case of connecting the VDR IF, please check
to the Connect
N
WAN（FGB2 Side）
It is the IP address of Radar IF connection side. N
②
VDR IF
（Router）
LAN （ Real Time
Monitor Side）
It is the IP address of Client PC connection
side.
N
IP Address It is the Radar IF IP address.
for Real Time Monitor It is the port for receiving real time monitor data.
Option PC It is the port number for communicating with the
Radar IF.
N
③
FGB
(Visual)
FGB It is the port number of Radar IF side. U
④
Terminal It is the IP addressed of the monitor terminals
Check mark of connection is needed in the Terminal block of the System
tab.
N
[Connect] To connect LAN and use, click the [Connect]
button.
⑤
Network
Connection
[Disconnect] To disconnect LAN and use as following, click
the [Disconnect] button.
･In case of disconnecting a LAN cable and
playback in somewhere else
U
⑥
VDR
Network
Shows the VDR network composition.
They are reference only.
U
*1: N: Necessary, U: Unnecessary
In case of client, the setup of the Ethernet tab is unnecessary to
change.
Note
To Next Page
Loading...
