JRC JCY-1800 - Set by Maintenance Software

Chapter9 Appendix
VDR/S-VDR Real Time Monitor / Installation Manual
66
STEP 1 Set by Maintenance software
(1)Open the Option PC（VDR Real Time Monitor）screen
(2)Click the [All Enable] button
(3)Check that the following addresses in VDR WAN and Option PC
・ VDR WAN=192.168.0.254
・ Option PC=192.168.0.251
(4) If the IP address is different, open the Network screen by the [Edit] button, and change IP
address.
When the [Default] button is clicked, default IP addresses are input.
(5) Click the [Set] button.
Setting by the Maintenance software is completion above.
After this, operate on the VDR/S-VDR Real Time Monitor.
[Default] button
VDR WAN
/Option PC
[All Enable]
button