35
3.2 Fishing Method and Corresponding Setup
The following describes standard setting suited for each fishing method.
Expressions used in the table below may vary according to the area our system is used
and the given fishing method.
The noise suppression is usually set to 3 or lower value. If you set
the noise suppression to a higher value, weaker response may not
be displayed on the screen.
3.3 Setup Changes Needed When Switched from Our Competitors
The following section describes the standard setup to be employed when you replaced
the competitive product with our system. Expressions used in the table below may vary
depending on the model, area the product is used and the fishing method.
You can select the display color optionally. For changing the col-
ors, refer to page 25 of the Instruction Manual.
For the ADC setting change procedure, see page 46 of the Instruc-
tion Manual.
Fish type Conventional models
Squid fishing Rod fishing Traul fishing JFV-100 JFV-120 JFV-216
Panel setup
GAIN 3.5
〜
5 3.5
〜
5 3
〜
4
− − −
STC 3.5 3.5 0
〜
3
− − −
CLUTTER 2 2 2
− − −
Fish finding menu
ADC MODE STD 7 5 3 1 2
STC MODE 50 50 50 or 100 50 50 50
TX CYCLE MODE SYNC SYNC SYNC SYNC ASYNC SYNC
Signal process Off Off Off Off 2 2
COLOR REJECTION - - - - - -
Main manu
CUSTOM 1 1 1 1 1 1
COLOR MODE NORMAL NORMAL NORMAL 3 3 1
BACK COLOR Standard Standard Standard Standard Standard Standard
Number of display color
To Next Page
Loading...
