What to do if the BUSY lamp is off and no voice is heard on my JRC Two-Way Radio?
If the BUSY lamp is off and you cannot hear any voice on your JRC Two-Way Radio, try turning the SQ control fully counter-clockwise, as the squelch might be closed. If the issue persists, the IF amplifier may have failed and should be checked.
How to fix no sound coming from my JRC Two-Way Radio when the BUSY lamp is on?
If the BUSY lamp is illuminated on your JRC Two-Way Radio but there's no sound, the issue could stem from a few causes: * A break in the speaker wire, in which case you should replace the speaker. * A loose connection in the connector, so check the connector and speaker cable. * A failure of the AF amp, so check the AF amp.
What to do if the CH indicator doesn't light on power on for my JRC Two-Way Radio?
If the CH indicator on your JRC Two-Way Radio does not illuminate upon powering on, it could be due to a discharged battery, in which case you should charge it. Alternatively, there may be a PS circuit failure, so check the voltages.
General| Modulation | FM |
|---|---|
| Frequency Range | 156.025 to 162.025 MHz |
| Power Output | 25W |
| Battery Life | Approx. 8 hours |
| Power Supply | 12 V DC |
To Next Page
