4-12
4.2.2 Entering a numeric value
This section describes the procedure for entering a numeric value.
Procedure
１．
Move the cursor to the field in which a value is to be entered by using .
２．
Set a numeric value to be entered by using and press or .
３．
Move the cursor to the right most field and press or .
The setting value is confirmed.
Select a field by using
Select a numeric value by using
ENT
ENT
If the numeric value that can be entered is restricted by an input range, enter the digits from
the highest order.
To prevent the value from exceeding the input range, the input of the low-order digits is
restricted by the value of the high-order digit.
Example) The input range is from 1 to 10:
If 1 is input in the high-order digit, only 0 can be set as the low order digit.
Power must not be off for 10 seconds after setting. When not doing so, the setting value
may not be saved.
Supplement
To Next Page
Loading...
