7-11
5.2.2 Local Properties Menu (LP0 PROPERTIES):
When pressing Menu button when in the BASIC Menu,
LP0 PROPERTIES is
displayed. Setting of Local Properties is done under this menu.
For example:
x Display type
x Select options to display in the MODE WINDOW
x Start-up DIM
x External inputs / outputs
x …
See chapter 6.5. Menu function summary for a complete list of Menu choices.
5.2.3 Remote Setup Menu (LS0 REMOTE SETUP):
When pressing Menu button when in the LP0 Menu,
LS0 REMOTE SETUP is
displayed. Setting of Remote Properties is done under this menu.
For example:
x Display ID
x DIM offset
x Remote Dim ID
x …
See chapter 6.5. Menu function summary for a complete list of Menu choices.
5.2.4 Remote operation Menu (R0 REMOTE DEV):
Remote User interface /“Master Display” to other equipment/device.
By pressing Enter in menu R0 the Display will establish communication with all
connected devices and display them in a list of device choices. When a choice is made
the communication starts with that device.
Esc is used to step back when needed to select equipment.
Examples of a Menu walk in the R0 Menu with two devices connected in the system:
R0 REMOTE DEV
CONNECT
Press Enter
SYNCHRONISING
(counting down…3…2…1)
Wait 3 seconds!
R1 DEVICE 1 OF 2
BTU 1 (T2A)
Press Menu
R2 DEVICE 2 OF 2
WTU 1 (R1A)
Press Enter
LHC 7.89 7.91
RC=495 1055:1055
To Next Page
Loading...