9-5
4.2.4 Saving menu content
When saving menu content by pressing ENTER, the following menu
appears for one second:
Aa FUNCTION
SAVE OK
or, when unsuccessful:
Aa FUNCTION
SAVE FAIL
before returning to the normal menu text. NOTE: A save fail may depend
on a busy flash memory and thus further save attempts may resolve the
problem.
If read-only access has been selected, the "no write access" text appears
for one second and the write operation is inhibited:
Aa FUNCTION
NO WRITE ACCESS
4.2.5 Menu function summary
The list is included for fast indexing.
Menus with access level “All users” are directly accessible.
NOTE: Menus with access level “Authorised expert” must be unlocked
and should only be used by trained service personnel. Note that some
non-default combinations of menu values may result in strange behaviour
of the SAL T-series speed log / echo sounder system.
No Access
Level
Name Default Range / info Function
MM (NORMAL
OPERATION)
speed info
presented
Timeout to normal operation after
180 seconds. Displayed
presentation according to chapter
"Normal operation".
A0
All Users
Internal PSALW
diagnostics
Number of active and
acknowledged diagnostic codes,
intended for service use
A101
All Users
ES SIMULATION
Diagnostic code depth simulation
status
A110
All Users
ES ALARM TEST NORMAL /
ACTIVE /
ACTIVE ACK
Diagnostic code ES Test Alarms
status
A140
All Users
POWER SUPPLY
LOW
Diagnostic code (transmitter) Power
Supply Low status
A201
All Users
SOG SIMULATION
Diagnostic code speed over ground
simulation status
A205
All Users
T2R MASTER FAIL
Diagnostic code T2R Master Fail
status (slave T2R / JP26)
A210
All Users
SOG Phase Roll
Diagnostic code Phase Roll test
status
A220
All Users
SOG Sig Balance
Diagnostic code SOG Signal
Balance test status
To Next Page
Loading...