9-6
No Access
Level
Name Default Range / info Function
A230
All Users
SOG T2T Failure
Diagnostic code (transmitter) T2T
test status
A240
All Users
SOG/ES TX MUTE
Diagnostic code external SOG / ES
TX Mute (transmitter muted) status
C0
All Users
CALIBRATION
Selects calibration menus
C1
All Users
BT Speed Cal +0.00% (-50% to
+50%)
Bottom track speed calibration
factor in %. step=0.01%
C2
All Users
BT angle Cal +0.0deg
(–180.0 to
+180.0deg)
Bottom track angular calibration
factor in degrees. step=0.1deg
D0
Authorise
d Expert
DEBUG
Selects Debug menus, only
intended for trained service
personnel
F0
Authorise
d Expert
Force Testing
Selects Forced testing menus, only
intended for trained service
personnel
M0
All Users
MISCELLANEOUS
Selects miscellaneous menus
M1
All Users
EepromRestore Disabled
Restore default values for all
EEPROM settings. Remember to do
a system reset after EEPROM
restore command.
M2
All Users
CPU Reset Disabled (Not stored)
Force a watchdog timeout that will
reset the log.
M4
All Users
BT Total Dist Dist=xxx
Total BT distance in nautical miles
M5
All Users
BT Trip Dist Dist=xxx (Reset)
BT trip distance in nautical miles.
Command ENTER resets the trip
counter.
M6
All Users
SW Revision Rev=xxx
The software revision of the
program
M7
All Users
Access Level All
Users
All Users: Some first level menus
are locked
Authorised Expert: No menus are
locked
P0
Authorise
d Expert
PARAMETERS
Selects Parameters menus, only
intended for trained service
personnel
S0
All Users
SETTINGS
Selects Settings menus
S1
All Users
PSALX telegram Enabled
Depth profile information for SAL
ESD (Echo Sounder Display)
S2
All Users
WATC telegram Disabled
Shall always be set to Disabled
S3
All Users
PSALW telegrm Enabled
Internal diagnostics code
transmission (PSALW)
S4
All Users
Max Ahead 41
Maximum speed magnitude [kn]
S6
All Users
Lock Timeout 20
Serial data output timeout when
losing depth lock [sec]
S7
All Users
NMEA Interval 1.00
Serial NMEA sentence interval [s]
S8
All Users
PSALN telegrm Disabled
Measurement quality information
transmission (PSALN)
S9
All Users
VBW format Extended
Select IEC61162-1 extended
sentence format with stern speeds or
earlier short sentence format (Ed 1)
Sa
All Users
Operating
frequency
150000 145000 Hz to
155000 Hz
Select operating frequency in steps
of 500 Hz. Default frequency value
(150.000 Hz) should always be used
To Next Page
Loading...