9-12
4.2.10.1 Menu M1 Restore EEPROM to default values
This menu restores the settings for all parameters of the EEPROM to
default values. WARNING: activating this menu erases all calibration
data and user specific settings. Press “+” to enable.
M1 EEPROMRestore
Disabled
Press ENTER to activate:
M1 EEPROMRestore
Enabled
Successful restore is presented as:
M1 EEPROMRestore
SETTINGSRESTORED
and unsuccessful restore is presented as:
M1 EEPROMRestore
ERROR IN RESTORE
4.2.10.2 Menu M2 CPU RESET
By activating this menu the retriggering of the watchdog circuitry is
inhibited, and thus a timeout forces the JLN-900 log to reset.
M2 CPU Reset
Disabled
Press + to enable.
M2 CPU Reset
Enabled
Press ENTER to activate. As the menu system is only seen on a remote
display, communication is lost.
4.2.10.3 Menu M4 BT Total distance
This menu shows the total (SOG resulting) distance for bottom track log.
Press "+" or "-" to change the distance value. Save value by pressing
ENTER.
M4 BT TOTAL DIST
DIST =RRRRR.RRNM
4.2.10.4 Menu M5 BT Trip distance
This menu shows the trip (SOG) distance since last reset for bottom track
log. Press ENTER to reset the distance to zero.
M4 BT TRIP DIST
DIST =RRRRR.RRNM
To Next Page
Loading...