JRC JLN-900 - Page 199

9-13
4.2.10.5 Menu M6 SW Revision
This menu shows the software revision of the application code.
M4 SW revision
Rev 702275XX
4.2.10.6 Menu M7 Access Level
Change access level for some first level menus. Step to the menu by
pressing "Menu". Press "+" or "-" to select access level. Save value by
pressing ENTER.
M5 Access Level
All Users
NOTE: For “All Users” some first level menus are locked.
Or
M5 Access Level
AuthorisedExpert
NOTE: For “Authorised Expert” all menus are visible and possible to
enter. The Authorised Expert access level shall only be used by instructed
service personnel.
4.2.11 Menu P0 Parameters for technical set-up
Only instructed service personnel are intended to use these menus. The
menus change internals in the SAL T-series log. Press "+" or "-" to select
write or read-only access, ENTER to go into settings sub menus.
P0 PARAMETERS
ACCESS DENIED
4.2.12 Menu S0 Settings for end user
The setting menus are used to change end user parameters for JLN-900
log. Ordinary users may set all menus. Press "+" or "-" to select write or
read-only access, ENTER to go into settings sub menus.
S0 SETTINGS
WRITE ACCESS OFF