10-15
C1.1 DRAUGHT COND.
FULL LOAD 0.00%
Menu C1.1 sets calibration factor for the selected draught
condition. Use – or + key to adjust calibration factor and
then Enter to save.
C3 MULTI-P CAL.
ENABLED
Menu C3 is used to store multi point calibration coefficients. Menu must be
enabled (change with + if disabled) to set or delete calibration points. Press
Enter to go down to enter the first calibration point.
C3.1 MULTI-P 1
UNUSED POINT
Menu C3.1 shows status for the first calibration point. If not
previously used row 2 will state “UNUSED POINT”. Use +
key to enable the calibration point.
C3.1 MULTI-P 1
ENABLE POINT
When point is enabled or previously used, press Enter to
step down to next sub-menu level.
C3.11 MULTI-P 1
EXPECTED 0.0KN
Use – and + to set which speed to be
calibrated for (expected) at that point (i.e.
the speed used at the calibration run).
Then press Enter to go to the next level.
C3.111 CAL-VALUE
10.0KN 23.45%
Use – and + to set
calibration value and
Enter to save.
C3.2 MULTI-P 2
15.00KN 34.56%
Use – key to delete an existing calibration point.
To Next Page
Loading...