JRC JLR-7500 - Line Display; Drawing Lines

4-25
4.3.10 Line Display
· Lines can be drawn between any two points on the plot screen.
· To turn off line display, set "LINE" to "OFF" as described in "4.3.12 Hiding Plot Screen
Symbols".
4.3.10.1 Drawing Lines
The cursor is used to set start and end points on the plot screen, and a line is drawn connecting
them.
Line start and end points can be registered as marks in the event/mark list.
If
is pressed before an end point is selected, the previous inflection point is deleted.
1. Press
, and display the cursor.
2. Press to move the cursor to the start point, and press
.
3. Press to move the cursor to the end point, and press
.
4. At the same position as the end point, press
again.
If steps 2 and 3 are repeated before step 4, a line will be drawn using the end point as an
inflection point.
Procedure
①Move the cursor to the start point
and press the ENT key.
②Move the cursor to the
inflection point and press the
ENT key.
③Move the cursor to the
inflection point and press
the ENT key.
④Move the cursor to the
end point and press the ENT
key twice.