JRC JMA-2343 - Changing the Range Unit; Measuring the Bearing of a Target

177
3.3.12 Changing the range unit
With this radar equipment, the range unit measured using the VRM or cross hair cur-
sor may be selected from among the following.
NM (nautical miles)
KM (kilometers)
KY (kilo yards)
(a) Select among "NM", "KY", or "KM" in the line "RANGE" - the menu "DISPLAY".
(b) Push the ＭＥＮＵ
ＭＥＮＵＭＥＮＵ
ＭＥＮＵ key.
The menu setting has been completed.
3.3.13 Measuring the bearing of a target
To measure the bearing of a target, the operator may select one of the following actions.
• Use EBL (electronic cursor)
• Move and use EBL (floating EBL)
• Use the parallel line cursor
• Use the cursor
There are three modes in displaying the EBL bearing
• Relative bearing display : R
• True bearing display : T
• Magnetic bearing display : M
 For details on display of bearing, please refer to "3.3.16 Switching the EBL and
cursor bearing display among relative, true and magnetic bearing display
mode".