JRC JMR-5410-6X - Using the Cross-Hair Cursor; Displaying Information in the Cursor Information Readout Area

4-3 Section 4 Range and Bearing Measurement Methods
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
APP A
APP B
1
4.3 Using the Cross-hair Cursor
When moving the cursor into a window, it changes to a cross-hair cursor. With the cross-hair cursor,
the bearing and position of a target can be measured.
The information that is measured by the cursor is displayed in the cursor readout information area.
4.3.1 Displaying information in the cursor
information readout area
Display the cursor information by using the following procedure.
[Placing the cursor inside of PPI]
When the cursor is placed on PPI, the cursor information on the cursor position is displayed in the
cursor information readout area at the top right corner of the screen.
Cursor readout
information area