JRC JMR-5410-6X - Moving a Dragging Anchor Monitoring Ploygon on the Context Menu; Changing a Size of a Dragging Anchor Monitoring Circle on the Chart; Changing a Size of a Dragging Anchor Monitoring Circle on the Context Menu

8-5 Section 8 Monitoring a Dragging Anchor
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
付録
8.3.4 Moving a dragging anchor monitoring
ploygon on the context menu
The moving of a dragging anchor monitoring polygon can also be executed from the context menu.
1 Click the right mouse button on a line of the dragging anchor monitoring polygon.
A context menu is displayed.
2 Click on [Move this object] on the context menu.
The cursor is set to the Edit cursor.
3 Move the cursor to any position and click the mouse button.
The dragging anchor monitoring polygon is moved.
8.3.5 Changing a size of a dragging anchor
monitoring circle on the chart
1 Click on the dragging anchor monitoring circle.
A square enclosing the dragging anchor monitoring circle is displayed.
2 Click on any of the vertices of the square enclosing the dragging anchor monitoring
circle.
The cursor changes to the arrow cursor.
3 Move the cursor until the dragging anchor monitoring circle becomes a required size
and click the mouse button.
The size of the dragging anchor monitoring cicle is changed.
8.3.6 Changing a size of a dragging anchor
monitoring circle on the context menu
Change of a dragging anchor monitoring circle can also be executed from the context menu.
1 Click on the dragging anchor monitoring circle.
A square enclosing the dragging anchor monitoring circle is displayed.
2 Click on any of the vertexes of the square enclosing the dragging anchor monitoring
circle.
A context menu is displayed.
3 Click on [Change Radius] on the context menu.
The cursor is set to the Arrow cursor.
4 Move the cursor until the dragging anchor monitoring circle becomes a required size
and click the mouse button.
The size of the dragging anchor monitoring circle is changed.