JRC JMR-5410-6X - Setting up the Display of Depth Graph; Setting up the Display of Water Temperature Graph

11-19 Section 11 Setting up Screen View
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
付録
11.1.14 Setting up the display of depth graph
When [Depth Graph] is selected in the classification pane, the “Depth Graph” dialogue is displayed in
the editing pane.
[Operation procedure]
Open the “Depth Graph” dialogue by using the following procedure.
[Menu] button → View → Depth Graph
The setting contents are shown in the following table.
Setting item
Description of setting
Setting value
Depth Range Select a depth range of the depth graph. AUTO / 50m / 100m /
250m
Time Range Select a time range of the depth graph. 10min / 15min / 30min /
60min / 12hour
Reference
Select a reference of the depth.
AUTO / KEEL
11.1.15 Setting up the display of water temperature
graph
When [Water TEMP Graph] is selected in the classification pane, the “Water TEMP Graph” dialogue is
displayed in the editing pane.
[Operation procedure]
Open the “Water TEMP Graph” dialogue by using the following procedure.
[Menu] button → View → Water TEMP Graph
The setting contents are shown in the following table.
Setting item
Description of setting
Setting value
Graph Colour Select a colour of the water temperature graph. Grey / Blue / Cyan /
Green / Yellow /
Orange / Dark Red
Time Range Select a time range of the water temperature graph. 10min / 15min / 30min /
60min / 12hour