JRC JMR-5410-6X - Checking the Sensor Source Status

Section 15 Maintenance & Inspection 15-6
Setting item Setting contents Setting value
STW Selects
a Speed Through Water sensor source from the
combo box.
When the sensor source is set to [MAN], a Speed Through
Water can also be input in the [STW] input box.
Speed Through Water value input range: 0.0-99.9 kn
MAN / Log1 /
Log2
COG/SOG
Selects Course Over the Ground/Speed Over the Ground
sensor source from the combo box.
When GPS is selected for the sensor source of [Position],
the same GPS is selected automatically.
Log1 / Log2 /
GPS / TGT
Time Selects a sensor source to be used for time correction of this
equipment from the combo box.
GPS
Ship’s Clock
Depth Selects a water depth sensor source from the combo box. FWD / AFT / MID /
AUTO* / E/S1* /
E/S2*
*1
When both Echo Sounder 1 and Echo Sounder 2 are installed as the water depth sensor
sources, E/S1 (AUTO) and E/S2 (AUTO) are displayed instead of AUTO.
15.1.6.2 Checking the sensor source status
Check the sensor source.
[Operation procedure]
Open the sensor source setting screen by performing the following menu operations.
[Menu] button → Maintenance → Sensor Selection/Status → Position Status
The following table shows the items that are displayed.
Display item
Displayed information
CCRP1/2/3/4 Displays any of CCRP1 to CCRP4 that is currently selected.
Displays the setting of the CCRP that is selected in the system configuration.
X: On-board horizontal axis position of CCRP1/2/3/4
Y: On-board vertical axis position of CCRP1/2/3/4