JRC JMR-5425-7X - Starting and Ending Dragging Anchor Monitoring; Starting Dragging Anchor Monitoring; Ending Dragging Anchor Monitoring

8-3 Section 8 Monitoring a Dragging Anchor
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
付録
8.2 Starting and Ending Dragging
Anchor Monitoring
8.2.1 Starting dragging anchor monitoring
[Operation procedure]
Open the dragging anchor monitoring screen by performing the following menu operations.
[Menu] button → Anchor Watch
1 When the dragging anchor monitoring screen is opened, the preview of the dragging
anchor monitoring area that was set on the chart is displayed (broken line).
When the dialogue is displayed, the own ship’s position is placed at the centre of the circle.
2 Set the dragging anchor monitoring to [On] by clicking on the [Monitoring Anchor]
button.
Dragging anchor monitoring starts based on the setting.
The dragging anchor monitoring area on the chart is changed to a solid line.
When own ship exits from the dragging anchor monitoring area, the "Dragging anchor" alarm is
displayed.
8.2.2 Ending dragging anchor monitoring
Set the button display to [Off] by clicking on the [Monitoring Anchor] button.
Alternatively, use the following procedure.
1 Click the dragging anchor monitoring circle.
A context menu is displayed.
2 Click on [Finish Anchor Watch] on the context menu.
The [Monitoring Anchor] button display is set to [Off] and the dragging anchor monitoring area
on the chart changes to broken line display.