JRC JMR-7210-6X - Pasting the Copied Route; Inserting the Other Route

9-31 Section 9 Route Planning
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
9.6.4.5 Pasting the copied route
The route that was copied to the last WEP of the route is pasted.
1 Click the right mouse button on the WPT No. of the WPT on which the route is to be
pasted.
The context menu is displayed.
2 Click on [Paste route] in the context menu.
The routes are pasted (inserted)
Note
After pasting the copied route, when a route planning error occurs as a result of recalculation of
the BWW, Distance, Total Distance, ROT, TWOL, and ETA, an error message is displayed and the
route will not be pasted.
Memo
The same operation is performed also when the next No. button of the last WPT is clicked.
9.6.4.6 Inserting the other route
Insert the route of some other file in the route that is being edited.
1 Click the right mouse button on WPT No.
A context menu is displayed.
2 Click on [Insert other route] in the context menu.
The [Insert other route] dialog box appears.
3 Select a route file to be inserted from the [Select Route] combo box.
4 Click on the [OK] button.
The route file is inserted.
Note
If the range can be inserted is exceeded, an error message is displayed and the route will not be
inserted.