JRC JMR-7210-6X - Creating an Object in the EBL;VRM Mode; Creating an Object by Specifying Latitude and Longitude

14-19 Section 14 Creating a User Chart/ Updating a Chart Manually
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
14.2.5 Creating an object in the EBL/VRM mode
1 Click on the [EBL/VRM] button on the drawing toolbar.
The user chart creation function mode is switched from the cursor mode to the EBL/VRM mode.
When the mode is switched to the EBL/VRM mode, the cursor changes to the following state.
The EBL/VRM mode is switched to cursor mode when the right mouse button is clicked on the
chart or the [Enter POSN] button on the drawing toolbar is clicked on
14.2.6 Creating an object by specifying latitude and
longitude
Using the [Enter Position] dialog box, it is possible to create an object at the specified latitude and
longitude.
Displaying the [Enter Position] dialog box
1 Click on the [Enter POSN] button on the drawing toolbar.
Note
An object cannot be created with the cursor mode and EBL/VRM mode while this dialog
box is displayed.
[Enter Position] dialog box
EBL/VRM base point cursor