JRC JMR-7210-6X - Creating an Object by Specifying the Latitude and Longitude; Creating an Object with EBL;VRM Operation

14-89 Section 14 Creating a User Chart/ Updating a Chart Manually
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
14.10.1.1 Creating an object by specifying the latitude and longitude
1.
Click on the [Enter POSN] button on the drawing toolbar.
The [Enter Position] dialog box appears (Refer to "14.2.6 Creating an object by specifying
latitude and longitude).
2. Enter the latitude and longitude of the position on which an object is to be created and
click on the [Enter] button.
An object is created on the specified latitude and longitude and the property information is
reflected in the object property dialog box. (Refer to "14.2.8
Object property dialog box".)
3. Adjust the parameters on the object property dialog box.
4. To create an object on another position continuously, repeat Steps 2 and 3.
14.10.1.2 Creating an object with EBL/VRM operation
1.
Click on the [EBL/VRM] button on the drawing toolbar.
The cursor changes to the EBL/VRM reference point cursor. (Refer to "14.2.5
Creating an
object in the EBL/VRM mode".)
2. Click on the position of the reference point of the EBL/VRM marker.
The EBL/VRM marker is displayed.